Protection d'écran HTC HD2 - SP P300 Twin Pack

This item fits my husbands screen perfectly, it was a bit of a minx to start with but that is because the screen is so big and there is a lot of coverage. Yes I put the cover on, sausage fingers was having an issue.

Works well, however still have not been able to apply without air bubbles, feel that the backing should be soft plastic so it can be peeled easily to allow for holding protector whilst positioning.

Fits perfectly and safely protects my screen.

This is a good screen protector but I'm not very good at fitting them ! I wish they would make them just slightly smaller as it's difficult to line these up with your screen precisely. You need to be patient but patience is a virtue and this screen protector combined with a gel case is what you need. Superfast delivery as well.

The major issue with this protector is that the width is exactly same as the width of the screen. This leaves no margin for error when fitting it. If you mis-align it slight the edge of the protector won't adhere to the screen properly. After 20 attempts I gave up because by then the adhesive side was covered in fluff. Don't waste your money.

I have never used a screen protector before, but boy I sure did not expect it to be this good! Very much recommended!

These work ok, if you're an expert at applying screen protectors! A bit fiddly and if not place correctly first time will result in air pockets or not holding securely. Good thing I had 2, as the first one was totally spoiled on the first attempt. I would probably invest in a better one next time.

Brought this to protect the beautiful screen of the HD2. It fits well and if fitted carefully canot be easily seen. However a word of caution, the standard screen is teflon coated and so resists fingerprints - these are not so you will find that they get muckier much quicker than the original screen, however a good product.

They say patience is its own reward - definitely true when applying any form of screen protector. The HD2 is no exception. Take your time - don't rush it. Make sure the screen is meticulously clean before you begin and gently blow any dust that has settled since you cleaned it. Make sure your fingers are equally clean - best to wear latex gloves if you can to avoid fingerprints. Peel off the protector using the handy little tab located on the side provided to ease separation. DON'T try, as I did, to separate the protector from its backing until I noticed the handy little tab. Tip: begin to apply the protector at the buttons end of the screen to ensure accurate fit around them. Hold the protector at an angle to the phone and gently let the protector out on to the phone's screen making sure you keep the protector parallel to the phone's edge as you go. Use your other hand to make sure there are no air bubbles by gently using your finger to push any bubbles to the edge of the screen. If you find you can't push a bubble off the screen, you can ease the protector back up to get rid of any bubbles until you reach the top. Be warned, once you have finished applying the protector, you can't easily lift it to get rid of that bubble you didn't see whilst applying it. Taking such care will reward you with a bubble free screen and the smug self-satisfaction that you have done something useful to protection your precious phone!!

First order from Mobile fun and incredible service. Not so chuffed with the screen protector. The massive screen means mm alignment. Slightly out on the sides and the protector hits the raised edge and it wont stick. These aren't the vacuum type so trying to realign reduces the stickiness. Used up both protectors and then found a trapped speck. They are easy to peel off which is the only bonus. I will bin this when I get a vacuum protector

Arrived promptly. Easy to fit and seems to do the job nicely.

It is virtually impossible to fit this cover and still have the screen look pristine. The cover is exactly the same size as the screen and therefore any miniscule overlap at the edge means unsightly bubbles that will never be removed.

Bought this with flexishield skin. Protects phone well and very pleased with service - got product the day after order.

Its tought to fit this without leaving little bubbles on the screen. A tiny spec of anything will cause big problems. When fitted it works great. Would recommend but you'll need to have patience to get it fitted correctly.

Does exactly what it should. Easy to apply and the service/delivery was impeccable. Thanks

Good protection for the touch screen. The protector is clear and is tougher than most of the generic ones. Once properly fitted, it just merged with the screen and was difficult to notice. As mentioned before, no reduction in screen sensitivity can be noticed at all. Fitting the protector was not difficult. Be careful not to have any dust or fingerprints on the screen. One problem that I have noticed was that the protector seems to interfere with the proximity sensor of the phone. Hence even before the phone is brought near the ear, the display goes off. I tried to adjust the position of the protector in multiple ways with no effect. This can be tricky if you want to use the on screen buttons whilst on the phone (you will end up pressing one of the phones button first to bring the screen back to life). I ended up ruining one of my screen protectors adjusting it back and forth trying to avoid it interfering with the proximity sensor. Glad I bought two. Hence the reason for me to give it only 4stars. Despite this hitch, I still agree that the protector is a fantastic one.

highly recommended...

Provides important protection for your huge screen. Tough, crystal clear & hard wearing. If it gets marked, remove & fit another in minutes. If well fitted it dissapears. No reduction in screen sensitivity has been noticed. This can be difficult to fit properly though, especially due to the large screen size of the HD2. The screen & your fingers need to be completely dust and dirt free, even a tiny speck will lift the protector giving the appearance of a bubble. This is true of ALL protectors. Good light & a very soft lint-free cloth is recommended. Do not touch the sticky side. Hold by the edges, place squarely at one end and 'roll' down smoothing out any air bubbles as you go. If not right carefully lift from a corner or the strip under the hard buttons & try again. Specs/dust stuck to the sticky underside can be removed to some extent with a fingernail before a re-try. It's well worth it...keep your HD2 screen protected & as new, preserve future value.

I usually buy the generic screen protectors but because the HD2 is a capacitive I tought I would buy the official protector and I am very glad I did. The protector doesn not just cover the screen area it covers the entire phone and is also cut for the buttons and light sensor too. When it's fitted correctly you really dont know it's there so my advice would be to buy it and remember to apply it with care!